Netopia 6.3 Manual do Utilizador descarregar pdf (Página 143)

143

Appendix A CONFIG Commands

This enables this particular tunnel. Currently, one tunnel is supported.

Speciﬁes the IP address of the destination gateway.

Speciﬁes the IP address of the destination computer or internal network.

Speciﬁes the subnet mask of the destination computer or internal network. The

subnet mask speciﬁes which bits of the 32-bit IP address respresents network

information. The default subnet mask for most networks is 255.255.255.0 (class C

subnet mask).

See

page 73 for details about SafeHarbour IPsec tunnel capability.

See

page 73 for details about SafeHarbour IPsec tunnel capability.

See

page 73 for details about SafeHarbour IPsec tunnel capability.

See

page 73 for details about SafeHarbour IPsec tunnel capability.

Example: 0x1234)

See

page 73 for details about SafeHarbour IPsec tunnel capability.

Note: Aggressive Mode is a little faster, but it does not provide identity protection

for negotiations nodes.

BOTH set security ipsec tunnels name "123" tun-enable

(on) {on | off}

BOTH set security ipsec tunnels name "123" dest-ext-address

ip-address

BOTH set security ipsec tunnels name "123" dest-int-network

ip-address

BOTH set security ipsec tunnels name "123" dest-int-netmask

netmask

BOTH set security ipsec tunnels name "123" encrypt-protocol

(ESP) { ESP | none }

BOTH set security ipsec tunnels name "123" auth-protocol

(ESP) {AH | ESP | none}

BOTH set security ipsec tunnels name "123" IKE-mode

pre-shared-key-type (hex) {ascii | hex}

BOTH set security ipsec tunnels name "123" IKE-mode

pre-shared-key ("") {hex string}

BOTH set security ipsec tunnels name "123" IKE-mode

neg-method (main) {main | aggressive}

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 160 161

Comentários a estes Manuais

Sem comentários